Activity Stream

Clean the outside, metal part, with a brass wire brush. Blow the inside out with compressed air, without getting right onto it. Don't use any...

The price to pay for quality. Thanks for the info. I would hate to be duped and end up buying a counterfeit Keihin carb. Eventually, I plan on...

Yep ..$190 isn't that bad at all, albeit a small carb. The price of a big PWK AS, FCR, or Lectron will really get your attention.

The route you're going, with a new carb, it's highly unlikely a full setup is going to be less then $100 and could very well be over $200 by the time...

Getting the itch to do an aluminum frame CR based trike build. I still have other priorities ahead of something like that, but I'm formulating a...

is your new carb a 350x carb or a 400ex carb? awesome find at a yard sale! Best I've found trike wise was a super clean 86 200s at a yard sale. jim

Will do. I'm sure there's got to be something that'll let me use the PWK carb if Mickey Dunlap can't help me.

A keihin Pz27 slide and cap will fit.

It's hard to believe nobody has done this before just picked up a 81 atc70 that needs the same thing done to it

Crap. Didn't realize you had a stud/flange mount. Apologies for giving you a bad lead. That being the case, the suggestion to check with Mickey...

Also. since the PWK is not a stud mount carburetor, what boot/intake mount do I need to buy?

190 for a carburetor is insane haha. But that's the price for quality product lol. Thanks for the help

This one looks to be the real deal. ...

That cover is going to look nice. It'll tie the lines of the vehicle together. Can't beat the old gas mantel lanterns. Something about the quality...

Yep, stay away from the Chinese carbs on Amazon and Ebay. All the positive reviews are either paid for or by people who don't know what a proper...

Doesn't look like Keihin makes your original 26mm carb anymore. That being the case, I would consider a new GENUINE Keihin PWK28mm. Here is a...

Contact Four stroke tech . Mickey has bolt on performance carburetors for that model . https://4stroke.wixsite.com/mysite

I stumbled across your channel a little while back. Good stuff ����

You are not going to believe this! https://youtu.be/aeToH5elERs

Yup, I totally get that! The issue is apparently instead of the oil going through the orifices to dampen the movement applied to the shock, they are...

The nitrogen pressure should be in the reservoir.

I’m curious if anyone on TWW has any experience with the adjuster needle orings on a 200X shock. In retrospect I should’ve done the suspension work...

So I am at the point now where I can only bump start it, it runs ok it Boggs at the top of 5th gear and will try to die while idling unless I give...

I didn’t get a chance to pull exhaust and check if it’s stopped up yet. Went on a little ride today, no problems at all. Gonna check exhaust and...

Got the Craftec Cover unboxed. Going to sit and have a Rockstar, read the instructions and watch the company's installation video. Just...

The choke plunger being removed will allow unregulated air into the engine through the choke circuit causing it to run lean and will most definitely...

Hey so the carb seems fine but I still can’t get it to start my only luck was when I put it in second and bump started it but it would then die so I...

Ok I will check that switch, I know I have spark I checked it by pulling the plug and putting it on metal and starting it I saw it spark, and I don’t...