Activity Stream

got any pics of them installed?

Post 7 more times and I think you’ll be able to posts pics. Shouldn’t be hard too replace your hub studs and if you went up 2mm in diameter could...

what kind of wheel is it? can you tell me the tire size on it?

Wel hopefully not everyone has left at this point. I’m headed out tonight. Life got in the way last weekend but it all worked itself out. Hopefully...

I did forget that the sprocket was so far out on banshees...... hmmm...... I'll keep thinking about my options. I did have to space out my yfz rear...

Nice work! bike looks great! Congrats on collage, I'm in my last semester.

You could still have low compression, if the timing is off, and it fires to early, that can rip your arm off. I would start with setting the timing,...

Dang Dude! I’d probably sell a nut before I let something like that go. I hope it gets some serious use by the lucky new owner.

I think we can rule out low compression, I nearly tore my shoulder out of its socket pulling it over lol. The carburetor I just cleaned and set to...

Low compression , improperly tuned carburetor or weak spark are usually the cause of fouling plugs .

It runs about the same with the airbox lid off, and also with the muffler off too. I did some investigation into the spark, I know the coil is good...

Finally decided to sell my old girl. I've had it for some time but it was just sitting in the corner of the garage.... Not getting ridden or not...

Great reunion thread. At least there are no independent fact checkers here, just people that are sure they are right.:)

I think you should stick with the bike linkage setup. It would be easy to limit travel with the bumpstop and probably a much better design. Not that...

If you remove the airbox lid and it runs better its prolly rich. If it runs worse you might have a spark issue. Just something you can try

Thanks guys. Did some Cardboard design last night. Decided the mounts I originally made were too small and I felt they were going to rip off the...

You end up with a similar offset problem using the so called "bolt on YFZ swingarm". Even though Yamaha YFZ quad and the YZ450f and the WR450f all...

Glad I could help.

You are welcome. That is one very nice 200x. Looks like its ready to go.

Perfect. Thank you!

Got some time in the garage again today and made some more progress. The front end is put together, and the tires and rims are on. You'll have to...

Cool, thanks shep!

Thanks, Mr.C. I already have the left hand master cylinder, but I didn't have the brake line to the rear. I just ordered the same one. Plus I ordered...

Congratulations on graduating college. I have contemplated putting suspension under my daughters 200s. Thanks for including so many pics and all the...

You're right. It does look a lot better with the rear end lowered.

Awesome thread. Thanks for bringing it back

I'm sorry that it took me a while to get back to this. My garage where I keep my trikes is in another town 15 miles west of the town that I live in....