Activity Stream

Did you ever solve your problem cause I am having the same issue

loooking for any news??

I put the whole towny engine in my 4-zinger but put all the stator and wiring of the 4 zinger flywheel and pullstart fit perfectly fine. only...

what happened to this buid???? Really curiours to see!!!!

Hi Karl, I might be able to help. I have a couple of OEM US 90 rear tires that hold air, though they show some age. I’ll double-check their condition...

Well…guess I’ll take it as a warning. I’ll continue and maybe make more visits to our wild places. I hope you do too. If you read history you know...

I guess maybe an easier question would be; can anyone tell me if the flywheel is supposed to seat up against the starter gear? It looks the me as if...

Thats what we call the Mexican sewer hole .......don`t go in the water ........you`re pecker will fall off...

Awesome! I am planning to pick up some remnants of a 1980 ATC185 in the winter. It is in a barn full of wasps and bees and its not worth getting...

This is what my plug looked like just a few days ago 38pwk 162 55 cej middle 1 full turn 32-1 dumonde 110. Runs great even pulls 6th in the sand....

Sent from my iPhone using Tapatalk

Thanks, MrC. I actually watched two of your vids on how to do the replacement. One of the Big Red and the other for the 350X. I believe you used...

Thanks! Much apprecieated!

Hopefully it didn’t! Seem to be running fine just checked it to give it a service and oil change. Thanks

This is the correct spark plug , DR8HS . The R stands for resistor , the original plug was a D8HS but they are not used anymore because they cause RF...

If it's a Yamaha 3 wheeler and not a 60cc it's a Tri-Moto, that's just Yamaha's name for 3 wheeled ATVs. In '84 there's the YTM200, pull start only,...

The way we spend our time needs to be enjoyable. So I did that again…. If we could just chill like him..

Thanks for the advice and reply! I still think you should do a YouTube video on the subject.. =;)

Good job, also note the lower race in the kit is reccessed into the bottom of the neck, below flush, if it isnt seated into the neck, it will not...