Activity Stream

Yes sir. Next door neighbor had one on a massive walk behind, self propelled mower. As a young kid I remember him being pissed out of his skull and...

I've never even SEEN a 2 stroke SuperTrapp!! Cool find...

Recoils were a rope with a knot and a handle.

Just thought these were too cool not to share.

bought a battery, fuel valve is gonna be here tomorrow. Looking at tires now, I don’t care for the various aggressive or v shaped treads, I’m only...

i sell a lot on ebay. some trim down some dont. https://www.ebay.com/itm/401515061694?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649

Sucks you can’t ride it dude. I’m going to test my back tomorrow.

You need 2 aftermarket exhausts? No a KX pipe will not fit without major mods.

Harbor freight predator

I’m over here in Harrison. Lived In Paragould a few years, got back to the Ozarks and lots of trails!

Alright well good news. Got in touch with the seller and there was a mistake with shipping but he took care of it and i received the lift Sent...

Careful them words may wake up “glamy”:beer

Black wire from the stator connects to the hot side of the coil , that’s all you need to get spark . The other wires coming from the stator are...

You’re an animal Shep!!!:beer

IDK if anyone could explain anything short of providing you with a wiring diagram unfortunately. It sounds as if your kill switch is out of the...

Dam shop, trying to find the right consistency isn’t difficult there’s a few different charts to look at to get close. But if a part needs to be a...

Hope this helps. Check this thread post #19 http://www.3wheelerworld.com/showthread.php/185866-Ol-Deuce?highlight=ol+deuce+adapter "HJ" ...

Secret formula well sorta :D. there’s a learning curve to get past- a clutch adj cover I don’t believe can be done. I can’t get or have found a firm...

You da man Shep!!

I’m pretty damn sure it’s a crack. I will double check and post pic tomorrow -Jake

He's got a very secret formula... He's trying to set me up for my 250SX and 350X. I love "expirements" :D

This is pretty cool Shep and I'm sure you've shared on this forum the process of making these seals. My question is how do you determine the correct...