Activity Stream

Took 2nd today on the polaris. It just doesn't have good enough suspension to go fast through the rough woods stuff. But it's fast as hell in the...

Do you (or anyone else) use a torque wrench for anything smaller than 8mm? And is so, what kind, or brand? I’ve never been able to get anything...

I hope you'll be enjoying the ride soon.

Ok guys: here we go again. Persistence pays off Quitters never win, winners never quit. Or maybe I just wanted to give Shad Hoe more reasons...

I have one , send me a pm with your number and I’ll text you pictures tomorrow when I’m in the shop .

Cheap and Easy seat cover install https://youtu.be/KQKTSw5DMB0

6 ft lbs is pretty std for a 6mm case screw .

A Trx250r has a factory regulator . The unregulated lighting systems like a 185s / 200s do not .

My SIL has installed LED headlights on his 86 TRX250R with no problems, both a 8" wide lightbar, and 2 4-LED amber pods (not all at the same time,...

That's where I ended up going with it. I don't have a book but was planning on putting the kick assembly in the right case half and everything else...

I always put the parts in the left Case half , mainly because of the inner kick starter assembly / gears . Not sure if it’s even doable any other...

Properly tuned mods aren't cheap. Hell, toys in general ain't cheap! You get what you pay for.

www.223cycles.net he has what you need. MrC.

First suggestion is only stick with used OEM or bare min Brand name parts. If it's a no name china part on ebay/amazon there's no telling if the...

Thanks for the reply / info. Yeah, I assumed that the timing would be different; that's why I was reluctant to just do a straight swap. I followed...

I am looking into simply replacing the carb completely with a real kehein carb, I’m just not sure if I wanna bite the bullet yet. Price tag is a...

heat, if you don't have a propane torch you can get something at a local hardware store. DO not start banging away on stuff until you use lots of...

Soak it with pb blaster or Kroil. Do this for about 3 days, resolving it periodically. Used a BFH. A heavy dead blow if you don't want to damage the...

There are two sizes of 400ex carbs 35mm and 38mm was used on the later models with the A/F screw plugged with a welch plug for no adjustment due to...

I might as well add my 2-cents... It's a Chinese carb just buy another $40 dollar new one not knowing that any replacement parts u buy may not fit it...

Good plan, needles need to be perfect, any bend or scratch will change how they work.

It used to run perfectly before it started this WOT trailprotrailprotrailprotrailpro, but since then it’s appeared to be lean.

Yeah, that’s what I’m going to do. I’ll likely replace the needle too because its the needle that came with the carburetor, which is made in china....

Sounds like the spring and check ball which acts as a detent is not there, or it has severe wear. Does the arm wobble a lot? The large phillips screw...

Clean it all up, dont be scared to just jet it pretty fat while you are in there. Run a new fuel line around the carb in a spiral so you can get the...

The pinout is really similar for ATC200X and the 84-85 ATC200S, but the 200x has a sensor ground (green/white wire) that the 200S grounds to the main...