Activity Stream

I title everything I am keeping. If its a flip or I am robbing it for parts I will not title it. I can get it done in PA for $27.50. I do the same...

Good job Shep! Sounds like a chip off the old block!

The best I can tell, the magnets are good on the flywheel. It has a strong attraction when I stick anything metal near it. And it is very clean and...

You sound like a great dad and it's starting to pay off..... Good job

Just to put an ending to my previous covid post, all is good (negative) as of a few days ago....yay. We all survived. In other news, we found out...

Sorry it sold a couple days after I posted here .

That's good information to have. Thanks Shortline. Time to look over what I've got and rebuild one to replace a leaky China carb on my daughters...

i need that exhaust, how much you want for it?

hello there, i got one of those and i need the plastic cover where the ignition switch and neutral light go, any of you got one?

Check the strength of the magnets on the flywheel . I’ve seen them weak and if their broken it will affect the spark . I’ve also installed a few of...

All the Atc 200 / 185 models are 22mm carburetors except for the 200x it’s a 24mm and the xr200 is 26mm . If your talking non OEM carburetors then...

YES! That is the gasket I need! Are you looking to sell that one by chance..? LMAO. That would be a good idea to make some, as you said though it...

I have a box of old carbs too. Some of them have different size slides. Any idea what models used a small slide carb?

thanks, when I get a chance I'll pull some float bowls to look. jim

The big difference in the carburetors are the float valves , their are two different styles , one has the metal clip and the other just slides in . A...

Awesome thank you!

I believe that it's a 1983 ATC200 engine.

Went for a rip on the Duck and then jumped off the bike and onto a riding mower and then back onto the bike. What the mower lacks it...

I've never seen the 86/87 200x, 350x rubber seal for sale separately. Should it be out there somewhere yes but finding the part number has lead me to...

Hmm I'll give it a shot, I'm just not sure if it will fit because the gasket on the 350x and some TRX300 models have a kind of lip on them idk how to...

This should work https://www.partzilla.com/product/honda/17632-435-730?ref=520d4bfc3f6e2eb7ae1a287d0e8076517b026482

For certain TRX300 model years yes, I've been searching and even in Honda part diagrams I can only find the gas cap (which is discontinued) part...

Wouldn’t the ones for the trx300 fit? I’ve bought some oem ones from partszilla