Activity Stream

Make sure your not missing the rubber plug that seals off the bottom of the choke Circuit . Comes in the factory rubber kit . ...

a person that likes to tinker could swap some of the parts off these cheap quads into other things. it's got a hydraulic rear disc brake, the motor...

Would you be able to reverse engineer it and make it out of Aluminum if I sent it to you along with a thick enouhh bar stock of Aluminum?

I have this four wheeler and it has no spark. It has no battery. I'm fine with using just the pull start and no lights or anything electrical...

It would probably be as easy or difficult as converting most other quads.

Are you on fb? A couple guys have gotten them reproduced Sent from my moto z4 using Tapatalk

I've had a few of them China carbs work OK but it seems they just throw whatever size jets are handy in them and they aren't marked for size. If you...

its machined uhmw........I've run them for years. nothing breaks. I know its uhmw because I milled one down to fit a 300ex motor over at HRE one...

I thought the exact same thing when I read the description of it and even with the pictures I thought the marks on it might be machining marks, but...

Sadly I don't have Facebook anymore. I decided because I don't have any use for the longer shaft since I don't have a first gen R I would try some...

I'm not sure that it is printed plastic. The description mentions both cutting and machining these. I didn't see any mention of 3D printing. It does...

That clearance look just about perfect to me.

It's amazing that it would run, much less move anyone down the road with those plugged like they were. I wonder if it will go faster now that you...

Tonight we tackle some of the more pressing issues with the Honda Ct 70 Clone. Handlebar replacement, Leaky Carb, rusted out seat pan. Video link...

Thanks, I will do that. makes sense since OEM products are usually the best route to go.

Noticed yesterday my turning radius going left was way worse than turning right so I pulled the front end off today and made some adjustments to the...

The ol' 200ES gets a little wheezy up there.

The only thing I don't like about those is they're 3D printed plastic.. I was looking for a metal one

It’s rides really good. The yz shock really needs a rebuild so it’s a little floaty in the back. I rode 11 miles today and my back isn’t sore at all...

End of story go buy it. https://drwperformanceatv.com/index.php?route=product/category&path=60_105

Drw case savers