Activity Stream

Welcome to the forum (",) Can you post some pics of the three wheelers for us please?

So this post is older than I am and i dont even think you will respond. But im thinking about doing this. How did it go for you?

True story: 1) I am still saving trikes but the camera on my phone is broken so I don't share; currently working on Big Red and Little Red pair. ...

good point about liability on something sold. jim

Just curious, does leaving something titled in your name up there also mean that you’re legally responsible for what happens to it? Had a bad...

Thanks it was pretty simple had to make a couple shims and spacers. Can't wait to see how it handles the tt racing.

Looks good on there.

Updated swingarm by 20 years 05 450r swingarm.

I title everything I am keeping. If its a flip or I am robbing it for parts I will not title it. I can get it done in PA for $27.50. I do the same...

Good job Shep! Sounds like a chip off the old block!

The best I can tell, the magnets are good on the flywheel. It has a strong attraction when I stick anything metal near it. And it is very clean and...

You sound like a great dad and it's starting to pay off..... Good job

Just to put an ending to my previous covid post, all is good (negative) as of a few days ago....yay. We all survived. In other news, we found out...

Sorry it sold a couple days after I posted here .

That's good information to have. Thanks Shortline. Time to look over what I've got and rebuild one to replace a leaky China carb on my daughters...

i need that exhaust, how much you want for it?

hello there, i got one of those and i need the plastic cover where the ignition switch and neutral light go, any of you got one?

Check the strength of the magnets on the flywheel . I’ve seen them weak and if their broken it will affect the spark . I’ve also installed a few of...

All the Atc 200 / 185 models are 22mm carburetors except for the 200x it’s a 24mm and the xr200 is 26mm . If your talking non OEM carburetors then...

YES! That is the gasket I need! Are you looking to sell that one by chance..? LMAO. That would be a good idea to make some, as you said though it...

I have a box of old carbs too. Some of them have different size slides. Any idea what models used a small slide carb?

thanks, when I get a chance I'll pull some float bowls to look. jim

The big difference in the carburetors are the float valves , their are two different styles , one has the metal clip and the other just slides in . A...