Activity Stream

Jason its finally coming together, looks good. I just made a "new" mold of those tank rubbers if you'd like new one's instead of one's i sent u that...

Well you gave me some motivation at the least. I'm importing the model into our printer software right now and can hopefully print one off soon.

Darn, you've got this figured out! I get it, the devil is in the details, but it sounds like you're in a really good position to pull this off. ...

The company I have been in talks w/ can create a mold of an OEM part, or a 3D printed part. I'd rather not take the chance at possibly damaging a...

So re-reading your post a bit: you'd produce molds then from a pristine 3d printed part then, rather than an original part? I see that huge...

If you could produce that, I think you'd be printing money. I think the target cost would be important too. Anything over 300-400 dollars...

Atd-atc on Facebook is repoing prm grab bars. I just got on3 for a 350x check them out.

I really don't want to try to mold the part myself as I don't have the room or time at the moment to tackle a project like that. I'd like to hear...

Yea, that's what I was thinking. Thanks for confirming from your experiences. I'm with you, if they weren't on your machine when you got it with no...

I'll probably just live with it as is until I've got the money to get it painted. I've actually got an 86 250SX tank that needs paint too, so I...

Most of the Alumilite line shows shrinkage numbers of between 0.0041"/inch to 0.01"/inch. On a 30" long part, this means shrinkage of between...

Hey newby200x I know that there a lot of guys here that do the resin casting. John Swineheart did a ton of it and made some really nice parts. ...

Thanks guys. I think I'm gonna run the pro taper adapters and a pro taper contour bar in ATV low bend. Also I have a hard time comparing measurements...

That cleaned up nice! If you are looking for a cheap alternative to painting the tank, you can get a tank cover instead. Either Ceet or Hi- flite...

yea im kinda stuck in the 80's

The difference on the rear fender w/ that magic eraser is remarkable. It seems like it would be ready for some 2000 grit sandpaper and then some...

From the research ive done, it looks to be a piston out of a CB175/CL175 etc. They are the only pistons i see with a tall dome and 52mm. This piston...

got my piston today, wrong one! I ordered it wrong. so a new one is on the way. still lots to do!