Activity Stream

trailprotrailprotrailprotrailprotrailprotrailprotrailprotrailprotrailprotrailprotrailprotrailprotrailprotrailprotrailprotrailprotrailprotrailprotrailp...

Good looking lineup Sent from my SM-G935V using Tapatalk

My unit lost another guy shortly after Jonsson. We lost Duclau in January. He had been diagnosed with cancer under a year ago, then he was gone....

If you happen to be in the market for an air hammer pm me. We have a couple new ones sitting in the States that we need to unload. See you on...

Very helpful....thanks for posting!!

And i know that you know that i know .........that the weather sucks where you live .........the weather does`nt suck where i live (well sometimes it...

Yep dam, 1st one Will see how it goes, will be a thrower if it doesn’t work out

. Went to one of the monthly vehicle auctions today that I frequent. hmmm...should I buy a few honda quads or some police bikes? :wondering ...

I think this happened to me today when I put on a fresh carb rebuilt by flyingW and gas came straight out the overflow. I picked the back end up and...

Anyone have any tips on what works to remove stuck/stripped oil pump screws? Also whats the best way to replace the case bearings? Heat in oven?...

Yep And Israel probably used some of those funds to build bigger and better walls for keeping Palestinians inside the reservation. Isn't it...

It's ok though because you can get your packages any day of the week thanks to the incredibly questionable deal that was struck between the United...

New here and could not figure how to start a new thread and just wanted to post this pic of my sons 2nd birthday present. 1973 atc 70. Gonna be a...

Two cans should do it I think. I have one on the frame now, but it obviously needs more coverage. I'm figuring the second can will finish the frame...

Pics on page 1 Plate is 3/8” thick

How many cans of passion red (?) did you have in the frame shoot? I ended up using three cans @ $19.95 a can shipped. Frames are kind of...

I realize you’ve already done the crank, but do you have pictures of your fixtures in use? How thick is the plate you made to separate the crank?

Nice job on the knife making attempt. Something I wouldn't mind trying. Myself. In fact I've been given thought to getting a few sharpening tools and...

I do. I made one just for pressing it apart. I think I will set it up in the press (when i can get back to the press) with a dial indicator zeroed...

What exactly do you do for a living? It looks like you dabble in everything.

Started to make something useful out of the scrap piles of end mills/bits etc. (well at least I repurposed one endmill!) I was finally able to...

Added a seal and a bearing I missed!

I will see if I can get it to .005-.006 without mucking it up. Do you have a strong plate with a slot in it to press it apart some?

Two things I recently realized. One is that this machine needs a new countershaft. I'd somehow completely forgotten about that until the day before...

I find that sometimes the needle/float just won't seat right after the bowl has been completely empty (after a rebuild for example). Once the gas is...

Im with these guys the chinese copies are known to give issues, and numbers are not equal as far as jet sizes etc. If your carb is running fuel out...