Activity Stream

So I tried to ASK BVC trikes if they could sell my their 250R headlight kit as a DIY since I already had a white shell. At the time they were not...

I just did the recomondations that " dougspcs " had in a post. 2.0+3.0 offset

yeah thats a 88 JS 550. paid 100 bucks for it like 10 years ago. has factory barcode sticker still on it.

Looks good. Looks to be a nice stand up jetski up there on the shelf too. Had a new 750 kawi stand up ski back in 93 for 3 summers, sold it and...

That's how it should have came from the factory! Care to share any details?

Haha!.... I got to give something for the next owner to work on. Although it's not leaking....your right about the countershaft.

Got the plow installed on the 84 big red. Needed to fabricate mounting hardware. This was my “beater” machine, maybe it it time for some TLC ...

Hit the rail trail on my 200x over the weekend. Some fresh snow to play in. I found out new law requires one rear view mirror on all ATVs in nh....

Hey Jack G can you show a few more pics of your speedometer mount please ?

Was the cable long enuff ?

Come on...split that sucker and powder coat...lol. Besides, that countershaft looks like it needs a little work to get the seal to last.

Final clean on the engine is done....gasket surfaces cleaned and new seals installed. Looks like it was painted before over the original finish so...

Got it. Thanks much

The 84 250r is back on the lift this week. I got a lot of parts in and had a lot to over come with this one. check it out....

Your a little late on your response. We knew a year ago.

Also the most important process is to have clean mating surfaces . I use Honda bond HT which is the OEM sealant .

Good morning, there is no gasket for the head cap, put a thin layer of liquid gasket on the mating surface, torque to spec., wipe off excess. Take...

There silicone just watch that you don’t plug the oil feed on the head when sealing them up

Nice work. They're like goggles for your headlights.

Nice work...

Been a long time but did you take the hi lo lever housing apart to see it all is well in there ?

I threw 2 on the classifieds and craigslist to see if I can get a trade for a truck project. it's a long shot but you never know. Been hobbling more...