Activity Stream

I spoke with Tammy and purchased another seat with a decent pan and all the studs. She has a useable foam for me and the pan is being shipped direct...

The gold would be tricky. That’s a good anodize finish on those isn’t it?

Suzuki LTA400

:D :beer :welcome:

It's a very special old tire but it's junk now. And, no one likes running a tube...

Andy, my friend. Why wouldn't you go grab a 10mm and 12mm wrench? That's pretty much all you need to remove the forks. But, the wheel has to come off...

You mean the lever? I would imagine a wave washer against a rotating lever would wear it out.

Australia?? Poor fella, will you even be able to ride it? That country seems to be treating it's people pretty lousy these days, but pampering...

If your pan is nice, the studs are a piece of cake to change/fabricate. Finding a good pan and good foam is the harder part. Tammy should still be...

Those rims are hard to find without any damage these days, and they aren't cheap. You can probably smooth down the outer lip very carefully with a...

For ANY plastic, just look underneath (or the back side) and it's easy to tell the difference from Vac Formed to plastic injection molded.

let’s try this way.

Can anyone tell me if this front fender is Maier or OEM? Rears are easy. I can’t tell the fronts apart…

Ok, I had to look again. You must not be seeing this: https://www.ebay.com/itm/174577110016

I’ve cleaned the polish remnants off the wheels, but I didn’t get them cleared. I guess Monday I’ll do that. Once dry, I can mask off the...

Thanks guys. I'll digest and will be back with some questions.

The ones I see that have that number have the petcock going horizontal and mine is vertical. I think with that configuration it would hit the battery...

Here is Deep Threat up on the four post lift. Its crazy, the size and quality of pics from an Iphone are too big to upload :lol::wondering

I have been checking in here at 3ww some and found this thread for the first time. Such a cool old school bike! Now I just need to remember to come...

I agree that you need to understand your front-end geometry before going further. I am not sure what the axle offset is on DRZ forks, but I am pretty...

Miss you Ol Deuce :cry: Update coming tomorrow on this 11 year old thread.

Sounds like I need to design and make the tools to take the cap apart and let you focus on the gaskets. Then I could offer refurbishment service…

The cap issue is, finding a way to open it up to replace gasket without destroying the cap itself. Honda designed it in a way that does make it...

Please put me down for a gasket when/if you make some. Thanks!

No the gaskets are different- not just a flat rubber ring its molded alot different. shep I was planning on doing a batch of them but wont be...

Can anyone confirm the 17631-VM5-300 gasket (for the 87 TRX200) will fit/work on the 86 350X fuel filler cap? The gasket is not listed separately for...

Just to tie this off, today I left a message for Tammy. My seat pan is okay but has a busted stud (maybe two). I found another pan donor on eBay...