2 85 tri-z's wisconsin $650

[4cfed]

http://appleton.craigslist.org/rvs/1515445648.html

one complete needs rebuild with banshee nerf bars.. other a roller

they have been on there for a while and the complete one ran so im guying someone didnt re jet for cold!

[racer....X]

Man! why do they all have to be so far away?? I havent seen or heard of a tri z around here scince the early 90s< and I want one bad!

[4cfed]

well... beats me... they seem to be starting to pop up again.. i missed out on one last winter... itp rear rimes with holeshots, dg pipe and silencer, ran and rode.. $500 bucks.. i missed it by about 25 minutes :(

[Xfile]

I should call the guy and see if he would trade stock parts + cash for the pipe and nerf bars...I don't think having a stock pipe on it and no nerf bars would effect it's value to much in it's present condition.

[Xfile]

Just sent him an e-mail....we'll see what happens.

[Xfile]

e-mailing him paid off....I got a new vesrah top end gasket kit, 2 gold back rims with tires, a decent yellow front fender, a good solid aftermarket pipe ( not sure of brand, but looks DGish.....mass produced, not sectional) and a very nice aluminum Answer silencer. All for $98 bucks. He's a cool guy, not crazy with prices. He has a 38mm round-slide, a flat slide 38? and also a ported cylinder plus tons of stock parts if anyone is interested.

[4cfed]

so.... i shoulda jumped on the deal back when the one ran... darn

[Xfile]

He said it still runs but the engine makes a loud pinging noise???I kicked it over and the compression felt OK but I didn't try to start it. It would still be a good builder. I bet $400 or so would take the 2 Z's and all of the parts. Not a whole lot for good cosmetic parts, but you could build a decent looking Z with some elbow grease.

[factoryX]

hm, loud pinging noise usually means high compression.