Back for good...

[three_wheelin45]

Allright im back for good...trike updates :cry: Ok so my trike is missing the right case cover on my back porch cause my dad had a gheto plan...I put some liquid gasket on a bolt(it was leaking). So when I did this idiotic idea I screwed it in to tight and the damn bolt head broke and now the bolt rod is off inside the case... So ive went threw 4 drill bits and 5 taps trying to get it out... its pissing me off so if yall have any ideas it would be highly appreciated..but as of right now our last result is buying a diamond tip drill bit.

[Thorpe]

Pull the case off and back it out with a vise grip.

[three_wheelin45]

why would u pull the case off? u gota get it out anyways...I just took the right case cover off and u can see it right there but i keep breaking taps...and Vise grips wont do it its broke off down inside it nothing sticking out...

[Walkerallen]

start with a small drill bit then work your way up from there to the correct size. i usually use 2 or 3 different sized bits

[three_wheelin45]

I did but its in there so tight cause that liquid gasket it just snaps the taps but that last one that broke made it twist a lil bit so mabey that diamond tip bit will do it.

[Xpress]

When in doubt, go diamond tip...

[HondaHarry]

find a reverse drill bit in the correct size, use some cutting oil, not WD40 or anything like that, and go slow. should back out. HH

[three_wheelin45]

When in doubt, go diamond tip... LOL yep but if i brake it ima be pissed cause the are like 70$ down here.

[1984ATC200S]

i would weld a nut it.. if you have access to a welder, heat from the weld helps loosen things up, then it'll back right out.

[1grindking]

all seem to be gr8 ideas but i think the back wards drill bit would be my 1st thing to try hope it wrks for ya dont forget to use a center punch lol

[three_wheelin45]

Allright thanks for the tips guys i think ima try the reverse drill bit.