PDA

View Full Version : Pulling a Hub



M1841
12-06-2011, 10:44 PM
I need to replace the rear sprocket on the '79, 110. How is the best way to pull the hub? I'm sure it'll be rusted tight with age.

just ben
12-06-2011, 10:51 PM
spray the hell out of it with some pb blaster( helps if you put it on it's side for it to soak in) then smack it with a deadblow from the inside,turning the axle as you go. heat also helps. heat the hub not the axle(if you can)edit... after spraying it let it soak a few hours or overnight

ytm200steve
12-07-2011, 03:26 AM
it helps to leave the tire on the hub just remove the one hub bolt if you cant pull it off just tip the wheeler a bit and try kicking the tire usualy works for me:p

M1841
12-07-2011, 06:41 AM
Thanks ya'll. I'll try to get it off when it quits raining