Rust Question & Parts Question

[gage]

Two questions, first what to do about this. Fixable? The rust. Best Way?137478 Second I'm new here and Ive been looking for a few parts, I'm in the middle of rebuilding a 1984 Kawasaki KXT 250 and I was curious if any one here had them or what is the best place to get them from. Carb boot/holder dealer wanted $65 for one looking for cheaper, Radiator, rear tires, reeds valve, left flywheel engine cover.

[twisted]

ehh, looks pretty bad, 3m makes lil scotch brite roloc discs that go on a drill, part # 07480, try those or u might just have to resort to sanding an polishing.

[James S]

the worst is you could replace the fork instead of trying to get the pitting out. Or you could
try sanding it out and then polishing it on a polishing wheel to get it back near its original finish.
Good Luck!

[drivetime]

the pitting seems pretty deep. Even if you get it all off it would be best to try and seal it somehow afterwards. Using a power tool to get that off will be a must though.

[JJMF1979]

Try soaking it that might take most or all of it off if you lucky but it still won't look that pretty