got clutch in having problem

[segers200s]

got the new clutch shoes plates n springs all in ready to go just dnt remember where the clutch adjuster is suppose to be when u put cover back on thanx

[tri again]

If you're talking about the adjuster screw you can see from the outside with the round dimpled disc,
on the inside.
Not sure it really cares. but best to screw it out of the way
so it doesn';t hang up while seating the cover.
Pretty sure it's reverse thread.

After the cover is perfectly seated, you'll be adjusting it anyway.

It wants to get slightly tightened down onto the internal clutch actuator parts and then backed off a little for free play.
so screwing it 'out' because of the reverse thread, actually pushes it against the internals.
(i think)

did you find a manual in the world class help section?
If not, I can try to send you the page.