PDA

View Full Version : cdi boxes interchangable?



superglide
12-22-2011, 08:14 PM
will a cdi box from another year an model fit my 84 200es big red? the wiring connection looks the same,but different part number.:wondering

atc500x
12-22-2011, 08:40 PM
85 trx125 84 trx200sx and atc200es only

Howdy
12-22-2011, 09:10 PM
will a cdi box from another year an model fit my 84 200es big red? the wiring connection looks the same,but different part number.:wondering

Are you sure yours is bad?
Howdy

superglide
12-22-2011, 09:28 PM
mine ohmed bad,new coil an still only runs for 5 minutes then no spark,till it cools down

superglide
12-22-2011, 09:35 PM
I was told it had to be the same or it will throw the timing out of whack

Howdy
12-22-2011, 09:38 PM
mine ohmed bad,new coil an still only runs for 5 minutes then no spark,till it cools down

I have found it's almost impossible to correctly check the CDI boxes with an Ohm meter. But some say it can be done.
Have you checked your exciter coil? Unplug the Black with red striped wire from behind the pull starter. Make sure it checks within spec. Then run the machine until it dies and check it again.

I only point out things like this to help people from buy parts they may not need. I might have a CDI at the shop but will have to check to be sure.
Howdy

atc500x
12-23-2011, 12:22 AM
Yes exciter coil is a source of problem on the 200 that run for about 30 year on the same exciter coil.New aftermarket are available for about 25$.Personnaly I have change a lot of 200es cdi,and they seem to have some problem....and the symptoms are mostly always the same,run well,turn it off and now won't restart,wait an hour and start like a new.

superglide
12-23-2011, 10:51 AM
i ohmed the black with red pinstriped wire,before i ran it it was 246,after it quit it was 264