rice
04-13-2012, 08:33 AM
I have been reading alot of good stuff on here... Trying to get the tri z running perfect and i am close. In first and second gear it will not hit the power band most of the time, If i punch it to the bar quickly some times it will, After 3rd gear its full rip every time.
I have not tried any plug chops yet because i am waiting for my new dg pipe to show up first. What i do know is that it has a 360 main jet, Everything is sealed and clean, new stock air filter, air screw is 2 turns out, 2 tiny pin hole exhaust leaks but sealed good to the jug, compression 125, fuel 20-1, outboard 2 stroke oil.(for now), a good amount of blue smoke but not too bad, after a few minutes you can barely see it anymore.
I cant seem to find the clip for the needle that people are talking about, Is it above the slide somewhere? Any other advice? Thanks.
I have not tried any plug chops yet because i am waiting for my new dg pipe to show up first. What i do know is that it has a 360 main jet, Everything is sealed and clean, new stock air filter, air screw is 2 turns out, 2 tiny pin hole exhaust leaks but sealed good to the jug, compression 125, fuel 20-1, outboard 2 stroke oil.(for now), a good amount of blue smoke but not too bad, after a few minutes you can barely see it anymore.
I cant seem to find the clip for the needle that people are talking about, Is it above the slide somewhere? Any other advice? Thanks.