PDA

View Full Version : 200sx question


mojave
11-18-2003, 10:14 PM
will say 250x/300ex hubs fit on a 200sx so the rims off these quads will fit
TimSr
11-18-2003, 10:38 PM
They are all 4/110 rims, so you wouldnt need to change the hubs. The only difference is that the TRX200sx came with 8" rims stock, while the others came with 9".
mojave
11-18-2003, 10:48 PM
i have a set of front rims off a 250x and the bolt pattern is more spread out than the 200sx
TimSr
11-18-2003, 11:42 PM
Sorry, I thought you were talking about the rears. 87 250X front was 4/110, 88-92 was 4/144. I dont know what the 200sx fronts were, but my guess would be 4/110 also, in which case you could use 87 TRX250x front rims, TRX250 front rims, 97-04 Recon front rims, TRX300 front rims, and Kaw 185 and 220 Bayou fronts just to name a few off the top of my head. I think it woudl be a lot easier, and cheaper to get rims than to replace front hub assemblies.
mojave
11-21-2003, 10:21 AM
i think my fronts are 4/80 if that sounds right i was searching yahoo and found that. the reason i was asking is because i have a nice set of front rims and tires off a 250x also it has drum brakes in the front will that make a difference. thanks paul
TimSr
11-21-2003, 11:24 AM
4/85 is the smallest Honda uses, and thast a TRX90. Measure the distance between the holes, center to center criss cross from each other. 110mm should about 4 1/4" .
mojave
11-21-2003, 02:45 PM
i measured them the rears are 4 1/4" and the fronts are only 3 1/4"
mojave
11-21-2003, 03:16 PM
i've added a pic to show the hub
TimSr
11-21-2003, 03:23 PM
That is 4/85. Are you sure this is a 200SX? Maybe Howdy can help ID it with the serial numbers, both of the frame, and the motor. You may have some kind of hybrid. My source only shows 4/85 being used on TRX90, and TRX125. I used to have a 200SX. You mentioned drum brakes, which I think it did have, but they were hydraulic in which case youd gain nothing in performance by going to disk. I dont even remember the front bolt pattern on mine as its been a couple years since I had it. Ill see if I can find a picture.
mojave
11-21-2003, 03:41 PM
i've added a pic of the quad its a 1986 200sx the front brakes are hydraulic i didn't care about having disk i was just wanting to put a little sportier rim and tire combo on the quad to make it look better. thanks for all the help. is ther any kind of adapter to put on it to change the bolt pattern.
mojave
11-21-2003, 06:08 PM
i just went to whitebros.com and they show the front rims for a 20sx as being 4/80-10mm