PDA

View Full Version : Any stuff to fix holes in plastics?



74sickness
06-21-2012, 04:07 PM
I managed to put a hole into my plastic and im wondering if there is anything i can patch it up with and what paint would i use? Thanks

remsandpets
06-21-2012, 05:16 PM
There are plasic welding rods that you can heat up and fill holes. Paint I'm not sure of.

74sickness
06-21-2012, 06:45 PM
I will try that thanks a lot

Tom'85350&70
06-21-2012, 06:55 PM
Where do you get them?

atcman12
06-21-2012, 07:25 PM
use those rods buy them off a internet site most likely for auto body shops like my dad ive seen them before snd then i would put some bondo on it and sand her down only in that spot and see if you can paint her with an oil based paint that wont chip:naughty:

remsandpets
06-21-2012, 07:45 PM
Might try giving a welding supply company a call. Some can be done with low temp like a heat gun, others take a higher air temp to melt. I don't remember using flame just very hot air.