honda250rboss
09-06-2012, 06:18 PM
hey there everone i have an AWESOME bit of advice for you. okay so my girl recently crashed my 200x and it tumbled 30-40 times down a mountain. so after following the debris field i found it in a gulley very injured. the worst was the entire fron end (forks, tree, bars, all levers) were destroyed. so i was looking for an alternative front end and HERE WE GOOOOOOOOO....
i have an 86 250r parts bike for my two 250r's i have that are pristine.
i bet ya didnt know that an 85/86 250r front end is compatable on a 200x!
the entire fron end including the tree and bearings will fit directly in the neck of a 200x as long as you use the bearing cups from the neck of a
250r.
oh and use the neck cap that goes under the bar clamp from the 200x it seals the gap perfect..
i swear it!!
this front end gives the 200x a super nice stance and a way plush ride compared to those old 31mm crap they come with.
TRY IT.
i have an 86 250r parts bike for my two 250r's i have that are pristine.
i bet ya didnt know that an 85/86 250r front end is compatable on a 200x!
the entire fron end including the tree and bearings will fit directly in the neck of a 200x as long as you use the bearing cups from the neck of a
250r.
oh and use the neck cap that goes under the bar clamp from the 200x it seals the gap perfect..
i swear it!!
this front end gives the 200x a super nice stance and a way plush ride compared to those old 31mm crap they come with.
TRY IT.