82_ATC_185s
09-16-2012, 12:11 PM
hello I have a 1982 Honda ATC 185s, the clutch was slipping last year and i finally ordered the new clutch for it(Centrifugal) installed it and didnt work, so i ordered a new adjuster screw,washer,seal,and nut, installed them and found a broken shifter actuating part(triangle ball retainer) replaced that and adjusted the clutch like the shop manual said(ACTUAL HONDA SHOP MANUAL) and it shifts but doesn't move. Last night after putting it back together with the NEW ball retainer it shifted and drove but wouldn't go into 2nd gear then wouldn't take off out of 1st after i stopped. I really need assistance and a video of any adjustments would be much appreciated...You can Email me(chrisrh97@yahoo.com)or just private message me on this site. Any help is much appreciated!
PARTS REPLACED:
RECOIL STARTER<-- W/ WORKING COMPRESSION RELEASE!
BALL RETAINER
CENTRIFUGAL CLUTCH
CLUTCH ADJUSTMENT HARDWARE(SCREW,WASHER,NUT,SEAL)
Its bored over and has a High compression Wiesco top end and rips wheelies thru 3rd gear.
PARTS REPLACED:
RECOIL STARTER<-- W/ WORKING COMPRESSION RELEASE!
BALL RETAINER
CENTRIFUGAL CLUTCH
CLUTCH ADJUSTMENT HARDWARE(SCREW,WASHER,NUT,SEAL)
Its bored over and has a High compression Wiesco top end and rips wheelies thru 3rd gear.