PDA

View Full Version : zinger 60 only runs on start quits on run after warm



BIGUM100
11-05-2012, 03:19 PM
can i bypass the start and run on 96 zinger 60 so it only off or on?157463

BIGUM100
11-05-2012, 03:21 PM
cafe racer lots of fun when runs :(
157464

HuffieVA
11-05-2012, 03:23 PM
I'm going to try to decipher what you are saying....

It only runs with the choke on.... is that what you mean?

johnny's X
11-05-2012, 03:37 PM
No it only runs when the on/ off switch is on start. You can disconnect the switch wires and cross over to the start. I chased the same problem with mine. I dont remember the colors on the wires. Just plug and play until you get it. Should solve your problem.

BIGUM100
11-05-2012, 03:44 PM
sorry, what im saying is that i can start it on the start position but when i switch it to the run position so it will rev past 2k rpm it wont it just dies. They have a rev limter box that does this but would like to remove that safety box

BIGUM100
11-05-2012, 03:49 PM
ok just im going to try that now, thank

thestud25
11-05-2012, 05:26 PM
My exhaust and exhaust port were plugged with carbon.

russ98atc
11-05-2012, 05:56 PM
I agree with stud , first clean out your exhaust. Also on the "expansion chamber" you can drill straight into the small hole where it meets the silencer, there's a small screen in there that gets plugged up, but don't drill to far or you'll go straight through the inner wall of the pipe (this fixed mine). If that doesn't work try cleaning the copper contacts in the switch with a q-tip and rubbing alcohol. Finally if that doesn't work clean out the carb, these zinger carbs are finicky so your going to want to clean it to the best of your ability. i usually run a piece of speaker wire through the all jets.