View Full Version : I need an oddball thread tap. .307-32 Schrader Valve Cap
I'm going to try and make some billet fork tube caps and need the tap for the cap size which is .307-32. The valve itself is .305-32, but I need the 307 tap. Just checking to see if anyone has one laying around before I hunt one down.
Scootertrash
03-30-2013, 08:10 PM
If no one comes up with one, try this:
http://www.e-taps.com/ofertapage%20140.htm
Home page:
http://www.e-taps.com/
Thanks for posting this, I'm always looking for places to get oddball tools.
Thanks Scoot, that was the only one I found and was hoping to not spend that much if someone had one laying around, but I may have no choice. Its a really oddball size and if you wanna play, you're gonna pay.
Howdy
03-31-2013, 12:58 AM
http://www.jis.com/itemdetail?ItemCode=REGA-TAP.307-32
http://www.drillingknowledge.com/campaign-tapping/?v=a2&infinity=gaw~US_Tapping_&_Hole_Making~Tapping~24022069081~thread%20tapping~ p&gclid=CL_k2cKVprYCFYxaMgodY30ABw
You need to contact them, Hope that helps.
Howdy
zzmegad
03-31-2013, 01:53 PM
id be tempted to do a test hole and see how a 5/16-32 fit, but now that I think about it that .307 is probably a pipe tap:wondering
edit: oh yeah not a pipe tap i forgot its the cap, for some reason i was thinking of a grease fitting when i typed that
Thanks Howdy, I'll call those places tomorrow. ZZ, I've read that the 5/16 tap is just a bit too loose. Its a little over .007 bigger than the valve itself. I'm probably just going to have to pony up and pay $50+ for it and suck it up.
Scootertrash
03-31-2013, 05:20 PM
id be tempted to do a test hole and see how a 5/16-32 fit, but now that I think about it that .307 is probably a pipe tap:wondering
I read a couple of posts on other forums when I researched this and if I remember correctly 5/16-32 is too loose.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.