PDA

View Full Version : porting and bore question



pounder76
09-18-2013, 03:04 PM
I want to get my cylinder bore honed and ported it's on it's first bore so I'm only going up one piston size but after it's ported will i have to get a bigger carb or just larger jets

curtis slawson
09-18-2013, 03:15 PM
I want to get my cylinder bore honed and ported it's on it's first bore so I'm only going up one piston size but after it's ported will i have to get a bigger carb or just larger jets

You will have to jet it up rich . My 200x bored 20. Over with high compression and a huge porting job & DG full exhaust. stock jetted is 108main now i have a 120 main jet in it also might have to go higher on your pilot jet too i just went up one size on the pilot jet