ScreaminRed
09-23-2013, 05:18 PM
Hello all,
I was thinking of running a bottom tap through it to see if that would clean
up the threads. If that doesn't work, what's the next best thing? Heli-coil or should
I go to the next mm size up? The bolt itself is fine. It had some goop on it to hold it in place.
Any ideas will be appreciated.
Thanks!
I was thinking of running a bottom tap through it to see if that would clean
up the threads. If that doesn't work, what's the next best thing? Heli-coil or should
I go to the next mm size up? The bolt itself is fine. It had some goop on it to hold it in place.
Any ideas will be appreciated.
Thanks!