Soxsux
02-05-2014, 08:37 PM
HI Guys,
I am new to the site. I am tyring to replace the centrifugal clutch on my 84 DX225. I have followed the instructions in the manual but I am not sure if I am missing something.... I removed the large nut on the crank shaft along with the tabbed washer. Per the manual you are supposed to align the curved part of the secondary basket so the Primary can slide off. This all seems very clear except my primary will not budge. I gently pryed on it but no luck. There is no threaded holed in the primary to use a puller.... Any help would be appreciated!!
I am new to the site. I am tyring to replace the centrifugal clutch on my 84 DX225. I have followed the instructions in the manual but I am not sure if I am missing something.... I removed the large nut on the crank shaft along with the tabbed washer. Per the manual you are supposed to align the curved part of the secondary basket so the Primary can slide off. This all seems very clear except my primary will not budge. I gently pryed on it but no luck. There is no threaded holed in the primary to use a puller.... Any help would be appreciated!!