mattsoch
06-17-2014, 07:37 AM
I have a 84 250R and a few parts bikes. I an trying to redo the rear swing arm off of a parts bike. The bearings that i pulled out of the carrier were 6007. I figured they were shot because there was ton of play in the axle. Though when i pulled them out I realized that they dont really fit the axle. So either the axle is screwed or the wrong bearings were used. So i have a few questions I was hoping for some help with.
Does anyone know what the axle ID should be?
What the proper axle bearing numerber should be?
Factory axle width?
Factory swing arm length?
Any help would be great.
Does anyone know what the axle ID should be?
What the proper axle bearing numerber should be?
Factory axle width?
Factory swing arm length?
Any help would be great.