1983 ATC110 New Carb Settings?

[angrydad2015]

I have a 1983 Honda ATC110, it was running fine, but the carb bowel was leaking, so I got a new carb, same thing, japanese heikean or something it says on it. Looks same except petcock is on bowel.

I got it to start and held the rev down for a second but died quick.

what I am asking is what should the 2 mixture screws be set at, how many turns from lightly tight closed.

Came from ebay new, and I didn't count turns on old carb before tossing it.=(

[Steve-Hoog]

Just checked the Ebay Rebuilt on my 83 110 which is running perfect: 2.5

Also last night fattened it up and raised the needle up one notch; the one with five settings. Was in the middle, now next to the fattest and it did make it run better.

[angrydad2015]

Just checked the Ebay Rebuilt on my 83 110 which is running perfect: 2.5

Also last night fattened it up and raised the needle up one notch; the one with five settings. Was in the middle, now next to the fattest and it did make it run better.


So turn both idle/air and idle/gas out 2.5 turns from lightly seated(all the way clockwise)?
I dont know what you mean five settings?

[Steve-Hoog]

The 2.5 is the screw to the left of the Idle Set Screw.

The needle is this: Was rebuilt on 3 and I went to 4 last night.

http://www.iwt.com.au/images/needle.gif

[angrydad2015]

The 2.5 is the screw to the left of the Idle Set Screw.

The needle is this: Was rebuilt on 3 and I went to 4 last night.

http://www.iwt.com.au/images/needle.gif


So, I set the screw on left(gas screw?) 2.5 turns out and then the idle air set screw in the middle from close to open.

[angrydad2015]

The 2.5 is the screw to the left of the Idle Set Screw.

The needle is this: Was rebuilt on 3 and I went to 4 last night.

http://www.iwt.com.au/images/needle.gif


so 2.5 on the left screw out and the center idle air screw set in the middle between open and closed?