ddiggerr
04-03-2015, 07:49 PM
I am having an issue with this frame. I have had it in the shop where we heated up the frame and with the help of a 6' bar stuck in the steering tube, attempted to straighten it out. It appeared to be fairly straight while on the bench, however, after setting motor back in and leveling out the handle bars, this is what it looks like ....
213572
Maybe I am pulling on the wrong part, however, there are signs of the front end being hit hard. The left side steering stop underneath front of steering tube is bent and the bar running in front of the motor, from top to bottom has been cracked in half and repaired by PO.
I am thinking I need to recut that smaller bar so I have a little play and then heat and bend again.
Open to suggestions..
213572
Maybe I am pulling on the wrong part, however, there are signs of the front end being hit hard. The left side steering stop underneath front of steering tube is bent and the bar running in front of the motor, from top to bottom has been cracked in half and repaired by PO.
I am thinking I need to recut that smaller bar so I have a little play and then heat and bend again.
Open to suggestions..