CHRIZZ
08-14-2015, 04:35 PM
I have a 1984 Yamaha YTM E (shaft drive) The axle bearing is real bad on the passenger side. on the drivers side it feels tighter. The Manual that I have for this machine says to take it to a Yamaha Dealer because I would I would mess it up. (its not going to the dealer) I have looked everywhere for the procedure to change the bearings with no luck. can anyone provide a link or tell me the correct procedure to change the bearings? Also should I change the bearings and seals on the shaft drive unit as long as it is torn that far apart? It has been taken apart down to the removing the axle part. so the axle hasn't been taken out yet.219935 Thanks Chris