PDA

View Full Version : No spark, 185 frame with a 200 bored power plant



m74cran
08-30-2015, 09:39 AM
HI all, I had this beast running 4 years ago and then life got busy and parked it, now it has no spark, yes I checked all wiring for shorts.

I do not know the year or model of the motor, it is pull start, not liquid cooled and it is an auto clutch I am thinking 200 or 200s, what are your thoughts, this would help when looking for parts.


It has stator coil behind the pull start that I replaced because it did not Ohm out right (had to solder a little extra wire on it because it was getting to short) now Ohms out to 262,on the pulser generator I am getting 31.1 Ohms, The coil was bad to, I got one at Napa but it did not fit so I made a bracket because it is smaller on the Primary I get 1.8 Ohms but the book says it should be .2 to .8 Ohms (gerrr) should I get a different one? and the secondary on the coil I am getting 11.56 and the book says it should be between 8 - 15 so I am good there, and the book says how to check the CDI box and that is not reading right either, I checked out Beatrice cycle and it looks like there are two CDI boxes, http://dratv.com/cdiunit88d.html this one is listed under 200s and has no rev limiter, and this one is listed under 200 http://dratv.com/cdiunatseeap.html

I took the carb apart and cleaned it but not sure if I trust the rubber O-ring on the bowl, when I brought the carb into a honda power sports shop to get a rebuild kit they said I needed the numbers off the frame because there were different carbs on the 200, well I have no idea where that frame is, do you have any suggestions