PDA

View Full Version : 400ex problems with starter clutch



HONDA_ATC_FREAK
09-19-2015, 10:40 PM
I recently had my starter clutch go out on my 2007 400ex i replaced it with a heavy duty L&L extreme starter clutch from raptoroneway.com. I pulled the flywheel and installed the new clutch and put in a new stock 30mm spacing collar, and put on a fresh gasket. I turned the flywheel and made sure it would spin freely put the cover on and put the bolts in and snugged them down to the last 1/16 of an inch and still turns. I tightened it the rest of the way and it won't turn anymore. I put the starter gear on and cover and tried to turn it over just to see if i wasn't trying hard enough and it won't turn. I've since taken it apart and put it back together 3 times with the same result i have an manual and i have followed it I'm at a loss as to what is happening. Anyone have any suggestions