Honda Junki
10-21-2015, 10:55 AM
Hi Guys,
Im struggling with my 3 wheeler pulling to the left kinda hard. I know for a fact the right tire is sitting a 1/2 inch farther forward then the left tire (I measured), So with that I've tried a hand full of times to loosen the axle up and straightening it out. The closest I can get it, is some where between 1/4 to a 1/2 of the axle being straight. Does anyone have any input?? Is there a certain procedure or step i'm missing when doing this?
Keep in mind I put new bearings in the rear end and when im trying to straighten the axle I try to keep the right amount of tension on the chain.
Im struggling with my 3 wheeler pulling to the left kinda hard. I know for a fact the right tire is sitting a 1/2 inch farther forward then the left tire (I measured), So with that I've tried a hand full of times to loosen the axle up and straightening it out. The closest I can get it, is some where between 1/4 to a 1/2 of the axle being straight. Does anyone have any input?? Is there a certain procedure or step i'm missing when doing this?
Keep in mind I put new bearings in the rear end and when im trying to straighten the axle I try to keep the right amount of tension on the chain.