View Full Version : 1983 Honda ATC 200 head gasket install help!
I am in the prices of putting a head and base gasket on my 83 ATC 200 and I have a few questions. Do I spray permatex copper on the gaskets before install? I also bought a top end gasket kit (winderossa), what are these other o rings for? How do I get the o rings for the dowel pins to go back in the head? Don't know if pictures posted but let me know. Any help appreciated thanks224379224380
shortline10
11-30-2015, 10:46 AM
No sealers needed except for the valve cover , use hondabond their . Only one O-ring is used and that one goes on the oil delivery stud , the alignment dowels if not scared up should go in their places with very little force , plastic mallet works well .
O yeah theirs a large O-ring used on the cdi cover .
When the studs came out there were small o rings around them but I can't seem to get them to go back in with the orings around them
shortline10
11-30-2015, 03:05 PM
Shouldn't be any o rings their , probably previous owners silicone remenance .
When the studs came out there were small o rings around them but I can't seem to get them to go back in with the orings around them
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.