B1GBen67
05-15-2016, 08:38 PM
Ok guys,
I'm working on an 85 250sx. Replaced the swing arm bearings because they were basically gone. Now that I am trying to re-attach the swing arm, the drive shaft isn't lining up properly. Looks to be about a quarter inch off. Worried the swing arm might be bent. Trying to get this thing ready for trikefest 2016, but currently stuck. Any Ideas?
I'm working on an 85 250sx. Replaced the swing arm bearings because they were basically gone. Now that I am trying to re-attach the swing arm, the drive shaft isn't lining up properly. Looks to be about a quarter inch off. Worried the swing arm might be bent. Trying to get this thing ready for trikefest 2016, but currently stuck. Any Ideas?