Newbie from Georiga

[Joshua81]

Hi, guys. Just joined yesterday. Im new to owning a trike, i rode a couple growing up. I currently own an 82 honda atc 110. I got it non-running for dirt cheap. I have currently pulled it completely apart and sent the chassisoff for sand blasting. Trying to decide if i want to try and hone the rust out of the cylinder or bore it out. Also have to replace the shift rod and lever plus figure out why it wont shift from hi to low. Like i said before im new to this and will be on here alot for help.

[AK47KID]

Hi, guys. Just joined yesterday. Im new to owning a trike, i rode a couple growing up. I currently own an 82 honda atc 110. I got it non-running for dirt cheap. I have currently pulled it completely apart and sent the chassisoff for sand blasting. Trying to decide if i want to try and hone the rust out of the cylinder or bore it out. Also have to replace the shift rod and lever plus figure out why it wont shift from hi to low. Like i said before im new to this and will be on here alot for help.
Welcome and oh boy did you come to the right place. I haven't had a 110 but someone will come by and see this. Pics of it if you have any are always appreciated

Sent from my SM-G935V using Tapatalk

[Joshua81]

If i could figure out how to add pics i would, not very good with online stuff. Give me an engine thought, that a totaly different story.

[Joshua81]

231859 here is a shot of it from my instagram.

[AK47KID]

Looks like a fixer upper

Sent from my SM-G935V using Tapatalk

[350for350]

Welcome. I say bore it. You're probably wasting your time trying to hone it. With 34 years of wear and the rust, you'll probably be ready for an oversized piston after you get the cylinder cleaned up. At least you'll be starting from scratch again with an overbore and you'll know that there isn't any taper in the cylinder.

[Maico]

Welcome!!

Dahlonega here!! :)