Herboso
09-12-2016, 08:09 PM
My 250SX came missing the original taillight as did one of my 200S's so I decided to make a custom light bracket that can be used on both ATC's and using a cheap LED light off ebay. Here are some pictures showing a little bit of the process.
234800
234801
234802
234803
I utilized the "C" shaped mounting holes on the rear grab bar by using tapered rubber plumbing washers. The bracket is firmly attached and won't rattle. Pictured is the 250SX but I am using the same setup for the 200S.
234800
234801
234802
234803
I utilized the "C" shaped mounting holes on the rear grab bar by using tapered rubber plumbing washers. The bracket is firmly attached and won't rattle. Pictured is the 250SX but I am using the same setup for the 200S.