View Full Version : Oem handlebar end caps
Herboso
01-18-2017, 09:29 AM
Question: Anyone have suggestions on how to reuse the OEM end caps on after-market handlebars? I want to replace my handlebars but I like the threaded OEM end caps.
Shep1970
01-18-2017, 12:42 PM
On one of the bikes i used this, 239023 it pushes outward as u tighten it. Like this http://ebay.to/2iBJnNe something like these But just use back part. (May find cheaper) or theres a rubber plug type that expands as u tighten.
You could weld a plug then drill+tap but the above works.
Assuming there 7/8 bars.
Shep
Red Rider
01-18-2017, 03:42 PM
You could weld a plug then drill+tapThat's the method I used.
Herboso
01-18-2017, 05:06 PM
Thanks. Good suggestions. I will give the first one a try first.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.