View Full Version : 1983 atc250r triple tree removal
Quagland
07-06-2017, 11:17 PM
Is there a special tool needed to take the bolt that goes through the frame?
AK47KID
07-06-2017, 11:31 PM
The top nut and washer come off then you gotta take the tip triple off and they should slide off. Keep a pan under the steering stem because the bearings will fall out. Mine were stuck so I used vice grips on each side to pinch the triple up above the shocks
Sent from my SM-G935V using Tapatalk
Red Rider
07-07-2017, 03:36 AM
Is there a special tool needed to take the bolt that goes through the frame?Yes, you'll need a spanner wrench to remove the nut that is below the top triple-clamp. That's the proper way to do it, but you can probably improvise with other tools.
Onetrackmind
07-07-2017, 10:17 AM
I always had trouble finding a spanner wrench that was small enough (even the adjustable ones) to fit that stem nut, so I made my own. Found it in the plumbing section of Home Depot and made a couple of adjustments with a grinder. It works perfectly and was less than $10.
https://uploads.tapatalk-cdn.com/20170707/7c9d34721390396a4532df1d3cfa881f.jpg
Sent from my iPhone using Tapatalk
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.