cevolaj
04-16-2018, 04:16 PM
So, I'm brand new here. I had been looking for a project to work on with my son and ran across a 1986 ATC125M this morning with no motor this morning that I picked up for 35 bucks. This particular motor doesn't seem to be too terrible common and from what I've read, there is not much in the way of direct bolt on replacements. I ran across this thread earlier:
http://www.3wheelerworld.com/showthread.php/186076-125m-jug-on-200x-bottoms-end
From what I"ve read. the 200x is too tall to fit on the 125 frame, but would it be any shorter/more likely to fit if the jug and rotating assembly were swapped from a 125 to a 200 block, or is that even possible? I would have posted on the original thread, but I just registered and it won't let me. I apologize in advance for my ignorance, I have very little experience with small engines/atvs.
http://www.3wheelerworld.com/showthread.php/186076-125m-jug-on-200x-bottoms-end
From what I"ve read. the 200x is too tall to fit on the 125 frame, but would it be any shorter/more likely to fit if the jug and rotating assembly were swapped from a 125 to a 200 block, or is that even possible? I would have posted on the original thread, but I just registered and it won't let me. I apologize in advance for my ignorance, I have very little experience with small engines/atvs.