PDA

View Full Version : YFZ - Banshee Drive Hub Interchangeability


El Camexican
10-01-2018, 03:51 PM
Does anyone know if the splines on the sprocket hub of a YFZ450 are the same as those on a Banshee axle? I know nothing else is the same on the two hubs, I just need to know if the YFZ hub fits the Banshee splines.

Thank you
yaegerb
10-01-2018, 05:07 PM
Yes they should be interchangeable. I believe they are all 24 spline.
oldskool83
10-02-2018, 10:58 AM
Just buy a banshee one, plenty out there, warrior and blaster are the same too last i knew. Bolt up a sprocket quard and go about your day.
El Camexican
10-02-2018, 10:43 PM
Just buy a banshee one, plenty out there, warrior and blaster are the same too last i knew. Bolt up a sprocket quard and go about your day.

Thanks. I already have a Banshee hub. I need to either modify it or replace it to suit my project.
BOB MARLIN
10-05-2018, 11:24 AM
There is some differences in the YFZ axle components depending on year model. It started changing in 2009/2010. I believe the drive hub splines and / or diameter was one of them.
El Camexican
10-05-2018, 07:48 PM
I had .200” milled off the Banshee hub. That should be good enough.

254944
oldskool83
10-10-2018, 07:57 AM
Make your own sprocket guard for that ting off something on ebay for a TRX450R...you will enjoy it.
El Camexican
10-10-2018, 08:47 PM
Make your own sprocket guard for that ting off something on ebay for a TRX450R...you will enjoy it.

One of those round plastic discs? Been meaning to look into those.
oldskool83
10-11-2018, 01:08 PM
no an aluminum one. I drill new holes from what i had a 200x and put on my raptor 660 which uses came hub as banshee.