1981 110

[Yzfireguy815]

If anyone has a picture of how the wiring harness is routed I’d appreciate it. Wrapping up my restoration and when I bought the trike the harness was missing. I know the CDI goes on the upper tab by my arrow, Still tracking down the rubber holder for it. Im just not sure on the rest , there’s another tab below that but it’s been damaged from what I can tell. Also not 100 percent sure on the routing of the brake cable through the forks .
Any help would be appreciated.

Thanks 257620

[DAM shop]

The harness needs to pass through your frame. The opening you see up towards the front of the trike on that side and it comes out of the opening above your top back mount, once you do that it will all make sense. The front brake cable runs down where you have the harness now.

Show us a pic of how you have your front brake cable now

[Yzfireguy815]

257621
257622

Coming through the frame makes total sense now ! Thanks . I’ve restored or replaced everything on this bike other than the original OEM plastics . Including engine rebuilt from bottom to top so getting excited for the finish line .

[Yzfireguy815]

One thing just became painfully obvious... I gotta pull the motor to properly run the harness through the frame .

[DAM shop]

One thing just became painfully obvious... I gotta pull the motor to properly run the harness through the frame .

You may be able to pull the top rear mount bolt and loosen the bottom, pull the front mount and see if you can swing it out of the way enough.

[Yzfireguy815]

I’ll give that a shot . Thanks

[DAM shop]

Looks good, nice job. Your brake cable routing looks to be correct I also think that the throttle cable routes the same way.