Insanity Plea
08-28-2019, 07:23 AM
Opinions on the need of the rear fender support stay (80116-HA2-000)? I searched the forum but came up empty. The bike I got doesn’t have one and the side of the fenders sag down, I’m thinking the lack of the support could be the reason, or it could just be from rollovers. The back portion is buckled behind the seat corners on both sides. I’m assuming they are old maier fenders, they have faded but aren’t cracked, no Honda identifications on them.
Lastly, does the support piece fit on the new maier fenders? I’d hate to buy one off FleaBay for $80 just for it to not work when I replace them.
I’m sure I’ll look back on my initial posts and laugh at my questions. When I was younger I didn’t give a crap about the stupid stuff, I just rode hard and couldn’t afford anything other than what was absolutely needed to keep it going... Yeah, you remember...repacking bearings instead of buying new ones, or whatever it took to save a buck for gas.
Lastly, does the support piece fit on the new maier fenders? I’d hate to buy one off FleaBay for $80 just for it to not work when I replace them.
I’m sure I’ll look back on my initial posts and laugh at my questions. When I was younger I didn’t give a crap about the stupid stuff, I just rode hard and couldn’t afford anything other than what was absolutely needed to keep it going... Yeah, you remember...repacking bearings instead of buying new ones, or whatever it took to save a buck for gas.