DREVS
09-03-2021, 10:13 AM
I have removed my right side outer case.
I discovered that my rotor holder oil filter was not really dirty but I did clean off what I found on it with some brake cleaner and a toothbrush.
I was missing the gasket that goes behind it so I ordered one along with another side case gasket.
There is a ton of nasty oil and sludge build-up at the bottom of the crankcase where the oil sits when it is not running. Can I blow this out with a brake cleaner or engine degreaser from a can with this case off and the drain plug out I think it would just run thru I just want to make sure I can safely spray brake cleaner in there I would really like to get that cleaned up in there since I got this case off.
My last question is I think I am going to need to buy a flywheel holder tool or something because I cannot tighten these 3 bolts that hold the rotor holder on. Any recommendations on which holder to buy?
Thank you guys you are awesome!
I discovered that my rotor holder oil filter was not really dirty but I did clean off what I found on it with some brake cleaner and a toothbrush.
I was missing the gasket that goes behind it so I ordered one along with another side case gasket.
There is a ton of nasty oil and sludge build-up at the bottom of the crankcase where the oil sits when it is not running. Can I blow this out with a brake cleaner or engine degreaser from a can with this case off and the drain plug out I think it would just run thru I just want to make sure I can safely spray brake cleaner in there I would really like to get that cleaned up in there since I got this case off.
My last question is I think I am going to need to buy a flywheel holder tool or something because I cannot tighten these 3 bolts that hold the rotor holder on. Any recommendations on which holder to buy?
Thank you guys you are awesome!