PDA

View Full Version : Correct clutch pattern



Tortuga
09-22-2022, 04:34 PM
1980 Honda ATC 110: Took apart my clutch and it was in this arrangement for the metal plates

https://ibb.co/h8pJSP8

But according to a Youtube video AND this schematic it appears #1 and #2 should be switched.

https://cdn.partzilla.com/cdn-cgi/image/quality=50/MTE/d/9/MjAxOTg5Ng-93bfee37.png

Which one is right? Or am I viewing the schematic incorrectly?

EDIT: #1 in reference is towards engine

shortline10
09-22-2022, 07:27 PM
It doesn’t matter if it’s 1 or 2 that go in first , just don’t locate the holes where there depressing the springs . The only steel plate that pushes on the springs is the last plate .
That middle plate would be for a clutch setup that had the short middle plate springs which doesn’t apply to your clutch .
Hopefully I explained it correctly lol .

Just looked at the partzilla diagram , do you have the short middle springs ?

Tortuga
09-23-2022, 08:15 AM
Yes I have two short middle springs.

shortline10
09-23-2022, 08:47 AM
Then the # 2 plate was assembled correctly .

Tortuga
09-23-2022, 03:37 PM
Awesome thank you so much