mixing oil.. what to do with injector.???

[bigredhead]

ok. working on a friends DT 125.. the gas is being mixed and the wire comming from the crank case oil injecter pump was simply cut off an inch above the case.

I got the right side case cover off to fix a huge hole that got in it from the previous owner wanting to help the new owner with a stripping kicker problem.. put a huge bolt, kicked it and it knocked an inch wide hole in the cover.

I JB'd it, and the cover is now ok.. going to use loc-tite gasket maker to seal it backup.. but want to know what i should do with the oil pump assy ?

[MTS]

just leave the pump in there-make sure the hole going to the head with the oil line is block if it has been cut so it dose not suck air.......basicly it just pre-mix wont hurt :)