ATC crazy
07-09-2005, 07:41 PM
Me and a friend are goin up to Patterson Mountain for some riding tomorrow. There is quite a bit of mud up there, and I have a hole in the rear driveshaft boot of my Foreman about the size of one of my fingers in diameter, from a stick that was punched through it. Im not sure whats in there as far as a CV joint or a *-Joint....I've never torn one apart before.
I thought about sealing it up with duct tape, but it would be almost impossible to get a water tight seal on it. What about some Rubber Cement if I plastered the hole with it. It needs to be able to flex with the suspension...so I thought this would be a good idea.... What do you think? It would only be a temporary fix until I get a replacement boot and tear it apart.
Any other Ideas?
I thought about sealing it up with duct tape, but it would be almost impossible to get a water tight seal on it. What about some Rubber Cement if I plastered the hole with it. It needs to be able to flex with the suspension...so I thought this would be a good idea.... What do you think? It would only be a temporary fix until I get a replacement boot and tear it apart.
Any other Ideas?