View Full Version : Quick feeler gauge question?
chris200x
09-14-2005, 12:06 AM
Are these the ones you use to measure and adjust the valves?
freewheel3
09-14-2005, 12:14 AM
Yes. There are other types as well. One type is similar to that one but the last half inch or so is bent @ a 45° angle to make it easier to get in tight spots.
There is also a type that is wire instead of the blades but I don't like them as much.
chris200x
09-14-2005, 12:16 AM
Thanks! :Bounce
bigredhead
09-14-2005, 08:43 AM
There are different range types .. ex: socket sets that go from 6mm to 17mm.. and others that skip a few sizes...
Getting the right tension on them takes practice tho, not too tight. but not too loose.. just what every man needs.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.